CMC
Full Member
Karma: 2
Posts: 154
|
okay fair enough
CMC
|
|
|
|
|
Logged
|
|
|
|
|
Sroufe7
|
Just so you know...when doing the 3.0L swap you can get a VR4 bottom end with the 4 bolt main  the SOHC 3.0L heads bolt right on the block |
|
|
|
|
Logged
|
|
|
|
|
JusBringIt
|
not bein a smartass..just questioning....how much would the overall improvement be of having the vr4 bottom end?
|
|
|
|
|
Logged
|
  "Engineered by nature, Engineer by nurture" |
|
|
|
Sroufe7
|
it's stronger. no performance gain.
You guys will not have any reason to worry about getting a VR4 bottom end.
Ours with forged pistons, STOCK rods, STOCK crank will hold over 450 hp
|
|
|
|
|
Logged
|
|
|
|
|
JusBringIt
|
well that's good to know...but by the time we approach that amt of power, i'm sure everything else needs to be built up
|
|
|
|
|
Logged
|
"Engineered by nature, Engineer by nurture" |
|
|
|
Sroufe7
|
none of you will make it that high...so don't worry about it |
|
|
|
|
Logged
|
|
|
|
CMC
Full Member
Karma: 2
Posts: 154
|
 ...i dont know I think i might be getting closer. CMC |
|
|
|
|
Logged
|
|
|
|
CMC
Full Member
Karma: 2
Posts: 154
|
Yes, it's a 3.5... look at the oil pan. Did you notice, i made the trans/engine braces work   CMC |
|
|
|
|
Logged
|
|
|
|
|
Sroufe7
|
that fuel rail look isn't going to work.  |
|
|
|
|
Logged
|
|
|
|
CMC
Full Member
Karma: 2
Posts: 154
|
yeah, injectors too small and the fuel line needs to bent up to clear PS pump  ... or this with some 90s with a line inbetween and other ideas (besides buy a rail form Disturbingmotors)?  CMC |
|
|
|
|
Logged
|
|
|
|
|
Sroufe7
|
get an end of a '95-96 fuel rail |
|
|
|
|
Logged
|
|
|
|
CMC
Full Member
Karma: 2
Posts: 154
|
here is the back side engine/trans. bracket...seal was replaced this weekend (thanks to DarkTengu)  CMC |
|
|
|
|
Logged
|
|
|
|
|
Sroufe7
|
it's not going to do any good to have a new seal if the axle isn't coming straight out of the transmission.  |
|
|
|
|
Logged
|
|
|
|
CMC
Full Member
Karma: 2
Posts: 154
|
really I looked at the 98' so many times to see if i could fab something up, but it is one solid piece - horrible design btw. I will sniff around at some of the local junk yards CMC |
|
|
|
|
Logged
|
|
|
|
CMC
Full Member
Karma: 2
Posts: 154
|
yeah, already milled down and bolted-up... all is left is DP/ fuel issues
CMC
|
|
|
|
|
Logged
|
|
|
|
|
Author
