stock exhaust
Pages: [1 ]
Topic: stock exhaust (Read 225 times)
TAVenge
Member
Karma: 1
Posts: 64
Learn to swim
anyone know off hand what the stock exhaust diameter is on a 95 v6?
TAVenge
Member
Karma: 1
Posts: 64
Learn to swim
Gr8witeLxi
Hero Member
Karma: 14
Posts: 817
In <3 with Chrome.
Mine is 2"...
last time i measured.
Scott
-->
http://www.cardomain.com/ride/2542075 <--
97 Chrysler Sebring Lxi
2.5L V6 - CAI, Accel 8mm wires, CCG UDP, high flow Down pipe/Magnaflow Cat, Neuspeed STB, Megan Racing rear brace.
JusBringIt
where did you measure??? scott's d/p is 2.25 and bolts right up to the stock. our stock is 2.25 OD
TAVenge
Member
Karma: 1
Posts: 64
Learn to swim
i'll go confirm it in a bit
Gr8witeLxi
Hero Member
Karma: 14
Posts: 817
In <3 with Chrome.
Confirmed ... 2.25.. sorry for the confusion...
Scott
-->
http://www.cardomain.com/ride/2542075 <--
97 Chrysler Sebring Lxi
2.5L V6 - CAI, Accel 8mm wires, CCG UDP, high flow Down pipe/Magnaflow Cat, Neuspeed STB, Megan Racing rear brace.
TAVenge
Member
Karma: 1
Posts: 64
Learn to swim
yep i checked it...had to do a bunch of math to figure it out from the circumference!
JusBringIt
Confirmed ... 2.25.. sorry for the confusion...
its ok, now u kno
Sroufe7
where did you measure??? scott's d/p is 2.25 and bolts right up to the stock. our stock is 2.25 OD
You are wrong...my downpipes is 2.5"
Stock exhaust is 2.25"
Gr8witeLxi
Hero Member
Karma: 14
Posts: 817
In <3 with Chrome.
I knew that..
Cuz the cat is the same size as the DP.. 2.5
Scott
-->
http://www.cardomain.com/ride/2542075 <--
97 Chrysler Sebring Lxi
2.5L V6 - CAI, Accel 8mm wires, CCG UDP, high flow Down pipe/Magnaflow Cat, Neuspeed STB, Megan Racing rear brace.
JusBringIt
where did you measure??? scott's d/p is 2.25 and bolts right up to the stock. our stock is 2.25 OD
You are wrong...my downpipes is 2.5"
Stock exhaust is 2.25"
on the OD it is 2.5..but it is pretty thick..which would make it 2.25 on the ID...right???cuz thats what i measured...
Sroufe7
on the OD it is 2.5..but it is pretty thick..which would make it 2.25 on the ID...right???cuz thats what i measured...
yes...exhaust tubing is measured on the outside. It's like 2.38" or so on the inside
JusBringIt
well when i was buying aftermarket parts for my exhaust, i had to go by both the inner and outer diameter so they could fit into each other. there werent any flanges involved.
Pages: [1 ]
Author
Logged
last time i measured.
