Johnny
Newbie
Karma: 0
Posts: 3
|
My baby, (99 Avenger w/V6 and auto tranny, 33K miles) has been sitting for a few months because of the cold weather. I started it and let it warm up for a few minutes. I was going to drive it today but it won't shift gears and the speedometer stays at zero while I'm moving. I couldn't go very fast because of it taching at over 3g's. The engine later stalled while coasting through a curve but I restarted it. Shortly after that I got a "service engine soon" light. I then parked it. I don't know if this is tranny or engine related problems. Any ideas?
Thanks!
|
|
|
|
|
Logged
|
|
|
|
Darktengu
Global Moderator
Hero Member
Karma: 63
Posts: 1871
Criminals survive because society is fearful
|
Likely a tranny issue. I'm not overly familiar with the A604 since I have the manual tranny. But it sounds like Limp mode. A common problem with your transmission type. Take it to Autozone or Advance Auto to get a diagnostic scan (it's free!)
|
|
|
|
|
Logged
|
 titan-racing.com Medialocker.org Mod List. Um WAY too many to fit on here. But the engine can handle about 800HP |
|
|
TSXtraitorboy
Sr. Member
Karma: 6
Posts: 297
Acura TSX
|
Definately sounds like "limp mode" for the transmission. I'm not quite sure about the speedometer not moving.
|
|
|
|
|
Logged
|
2000 Sebring LXi (SOLD)
2004 Acura TSX 6 spd
|
|
|
|
JusBringIt
|
speedometer....probably stuck. u can try taking the face off and giving it a push start. other serious issues would be a bad speed sensor.
|
|
|
|
|
Logged
|
|
|
|
Johnny
Newbie
Karma: 0
Posts: 3
|
I called a mechanic and he said it sounds like a speed sensor. It's going to his shop tomorrow.
Thanks for your replies.
|
|
|
|
|
Logged
|
|
|
|
Johnny
Newbie
Karma: 0
Posts: 3
|
I forgot to mention...I took Darktengu's advice. I took it to Auto Zone and I got three error codes from the diags. Vehicle Speed Sensoe Malfunction, Tranny System Control Malfunction, and Gear 1 Ratio Incorrect.
Time for some maintenance!
|
|
|
|
|
Logged
|
|
|
|
|
|
|
Shiano
|
don't forget about that little Tranny solenoid that Chrysler NEVER (on pain of death) mentions that solves what comes with a rebuild.
|
|
|
|
|
Logged
|
|
|
|
|
Antony
|
When some like my tachometer or half of my speedometer doesnt come on i just smack the bash board above it and it comes on
|
|
|
|
|
Logged
|
 -->  |
|
|
mcgyvr
Newbie
Karma: 1
Posts: 37
|
replace the input and output speed sensors. only one is the problem but you might as well replace both.
Simple fix, takes like 5 minutes if your handy.
|
|
|
|
|
Logged
|
|
|
|
Darktengu
Global Moderator
Hero Member
Karma: 63
Posts: 1871
Criminals survive because society is fearful
|
When some like my tachometer or half of my speedometer doesnt come on i just smack the bash board above it and it comes on
LOL time for a new gauge cluster. eBay 20-50 bucks. Or Nykon is whoring himself out BIG time for parts. |
|
|
|
|
Logged
|
titan-racing.com Medialocker.org Mod List. Um WAY too many to fit on here. But the engine can handle about 800HP |
|
|
mcgyvr
Newbie
Karma: 1
Posts: 37
|
When some like my tachometer or half of my speedometer doesnt come on i just smack the bash board above it and it comes on
LOL time for a new gauge cluster. eBay 20-50 bucks. Or Nykon is whoring himself out BIG time for parts. all you need to do is remove the cluster and clean out the pressure contacts on the rear of the unit. just a little sand paper will do. also make sure when its replaced its fully seated and secured. No need to buy a new one. |
|
|
|
|
Logged
|
|
|
|
|
|
|
Shiano
|
probably about 300-600 would suffice. you know I'M a detail person.  |
|
|
|
|
Logged
|
|
|
|
|
Author
