I have a problem with my window. Sometimes when i go to shut my door the window seems to pop out and if you turn around to look you can see a gap between the window and the seal. Any ideas? And another thing, how hard is it to change the dash light for the fuel gauge?
Dash lights are simple, Lower your steering wheel completely. Two screws on the gauge trim. Four bolts holding in the gauges, then pull the gauges straight out. You'll have to tilt them to get them past the steering column. Then just replace the bulb!
As for the window shut the door and look from the outside see if something is blocking it.
Logged
titan-racing.com Medialocker.org
Mod List. Um WAY too many to fit on here. But the engine can handle about 800HP
I never shut my door with the window. I have researched on here before and heard what could happen when you shut the dorr using the window. I get on to people about doing that. I think the person who had the car before did it cause you can go to the passenger side and it doesn't rattle or go off track. So where would I have to tighten them back up at?
Ok I took the panel off and tightened all the bolts. I even checked the hex nuts and they were all tightened. Did I do something wrong? It looks like I made the window closer to the seal and it doesn't stick out but the window still seems loose and I checked the passenger side and that was fine.
Hey I know this post is a little late, but if you have been cautious not to close the door by pushing the window...chances are the weather stripping is what is causing the window not to close all the way...ive owned two avengers and have had that problem with both, the weather stripping pulls away from the metal and blocks the top of the window from closing...i usually just push on the top of the window after i close the door and it snaps shut, which im sure is probably not the best thing to do but oh well. I also had my old avenger into a body shop after it was in an accident and asked them why the window was doing that and they told me the exact same thing, its the weather stripping...but they didnt want to mess around with it because the clips that hold it on could easily break making it a much more costly repair.