hey guys, i'm very new to this car...as a matter of fact i have no experiance with this type of car or motor at all.  I know enough about motors just not this one.  So i have a bunch of stuff i'd like to order but thought i'd run it past you guys first. 

I'm thinking about ordering everything i can from either partstrain or drivewire and picking some other stuff up from advance autoparts unless you guys have had bad experiances either of the mail order places?  Here goes:

it need rotors bad, but i'm checking into ebay drilled rotors
denso oxygen sensors
felpro intake and valve cover gaskets
fram pcv
borg warner cap and rotor
bosch plugs 4301
fram fuel filter
gates timing belt kit

I'm thinking it's going to need a new exhaust system as well, from the manifold back including the cat.  Any one have a recomendation for finding a stock replacement or aftermarket(cats to). 

Well let me know if those brand names sound good if there is a better part out there.

As long as i'm asking questions to......what rims fit on this 95?  do eclipse/talon rims fit?  what about stratus?  any other rims fit?

THANKS A LOT for the time guys

Brad

thanks a alot.  I didn't know the stock exhaust was stainless...i could've wasted a bunch of money on that.  I think the felpro gasket kit is a rubber gasket that does include that plug donuts to.  I forgot about the wires to...thanks



Brad

Sounds like a good start  How many sensors did you buy? If youve got the 2.5L then your gonna need 1 more of each sensor. Were you getting a service engine light at all?

yep, on the 2.5L theres 4 total,  2 upstream sensors and 2 downstream sensors. Upstream rear is on the rear exhaust manifold, upstream front is in the downpipe after the front collector. Both downstream sensors are right next to each other, right after the collector for the rear bank