ASOG Forums

Does anyone in here know where I can get an ECU pinout diagram for a 96 with an automatic transmission?

1-downstream left o2 sensor
2-ignition coil driver #1(2.0)
3-ignition coil driver #2(2.0)
4-generator field driver
5-N/A
6-ASD relay output
7-injector driver #3
8-check engine lamp driver
9-lamp check driver
10-ground
11-ignition coil driver
12-speed control on switch sense
13-injector #1 driver (2.0L)
13-injectior #1 driver (2.5L)
14-injectior #6 driver (2.5L)
15-injectior #5 driver (2.5L)
16-injectior #4 driver (2.0L)
16-injectior #4 driver (2.5L)
17-injectior #2 driver (2.0L)
17-injectior #2 driver (2.5L)
19-high speed rad fan relay control (2.0L)
19-high speed rad fan relay control (2.5L)
20-fused ignition switch output
22-speed control lamp driver
23-fuel level sensor signal
24-knock sensor signal (2.0L)
26-engine coolant temp sensor sig
28-high spd rad fan relay control (2.5L)
29-upstream left o2 sensor signal (2.5L)
30-upstream oxygen sensor signal (2.0L)
30-upstream right o2 sensor signal (2.5L)
32-crank position sensor signal
32-camshaft position sensor signal (2.0L)
33-camshaft position sensor signal (2.5L)
35-throttle position sensor signal
36-map sensor signal
37-intake air temp sensor signal
38-a/c clutch switch sense
40-egr  solenoid control (2.0L)
40-egr solenoid control (2.5L)
41-speed control switch signal
43-sensor ground
44-8-volt supply
45-power steering press sw sense
46-fused b(+)
47-signal ground
48-idle air control motor #3 driver
49-idle air control motor#2 driver
50-ground
51-downstream right o2 sensor signal
55-low spd rad fan relay control
56-generator lamp driver
57-idle air control motor #1 driver
58-idle air control motor #4 driver
59-ccd bus (+)
60-ccd bus (-)
61-5-volt supply
62-brake switch sense
63-torque management request sense
64-a/c comp clutch relay control
65-sci transmit
66-vehicle speed sensor signal
67-auto shutdown relay control
68-evaporative emission solenoid control
69-high speed cond fan relay control (2.0L)
69-high speed cond fan relay control (2.5L)
72-leak detection pump switch sense
73-tach signal
74-fuel pump relay control
75-sci recive
76-p/n position witch sense
77-leak detection pump solenoid control
78-sc vacum solenoid control
79-aspiratior solenoid control (2.0L mtx)
80-sc vent solenoid control

This is the ECU pin-out I got straight from the Chrysler service manual. It covers all 1996 Avenger/Sebring applications wether they be I4 or V6, manual or automatic. I hope this helps someone else out as it did me!